Aluminum rod continuous casting and rolling line
- Courier
- In detail
(View map)
1.Application
This production line is used to produce conductive aluminum rod of Φ 9.5mm,
Φ12mm by means of continuous casting and rolling.
2.Precise Process Flow
2.1.The process flow chart is as follows:
Ordinary aluminum ingot and scrap |
↓
Melting furnace |
↓
Holding furnace |
↓
Continuous casting machine |
↓
Oil Hydraulic shearer |
↓
Continuous rolling machine |
↓
Double basket rod rewinder |
↓
Aluminum rod |
2.2.Molten aluminum or prepared aluminum melt flows from the holding furnace into the casting machine via the launder, where it is cast into a trapezoid ingot with a cross-sectional area of 2400mm2. The oil hydraulic shearer cuts off the waste end and press it smaller or pointed so as to feed into the rolling machine, where it is rolled, and after passing through the grease box and the guide pipe, aluminum rod is finally laid down in coil in the basket on the trolley.
3.Main Technical Data
Diameter of conductive aluminum rod∮12mm, and ∮9.5mm
Output capacity: 2.5~5ton/hr.
Overall dimension: 32.05×7.2×4.2m